adding t-1 to 1232 digital?

[steve2653]

what programming needs to be done when adding a t-1 to a 1232 digital? The manual I have doesn't mention anything about programming the system for the csu?

 

[mrpeabody]

T-1 was not supported in the KXTD-1232 until release 4. Look at the bottom of the cabinet for a round white sticker with a number on it. If there is none, or it is less than 4, than you have to upgrade the software. Of course, you also have to buy a T-1 card. Contact a local dealer for purchase.

 

[steve2653]

Thanks for your reply,we already have the t-1 card,and it is mounted on the cabinet,but we dont't have any programing info in our manuals for the t-1 card,but i will check the release number though, thanx again mr.peabody