BCM400, 3.7 software, 2/6 split, PDD. Bus 2, 3, 4 have DSM32+ cards with correct dip switch settings. Bus 5 has a DSM32 (no +) card, also with correct dip switch settings. I can only get the first 16 ports to work on the DSM32 (no +). The second 16 ports just continually flash. DSM32 card is in the expansion cabinet. No problems with the other cards in the main cabinet. Any ideas...anybody...anybody???
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Adding MBM 1
- Thread starter Quiggly
- Start date
This is from memory, so your mileage may vary. The DSM32+ modules are double density so dipswitch 1 is off. For the DSM32 dipswitch 1 should be on.
Brian Cox
Oregon Phone
Brian Cox
Oregon Phone
- Thread starter
- #3
-
1
- #4
The DSM32 is single density, so it will take up 2 buses on your system (5 & 6). If a module is already using bus 6 you will have a conflict. If you are low or out of resources you will need to replace the DSM32 with a DSM32+ so that it only uses one bus.
Brian Cox
Oregon Phone
Brian Cox
Oregon Phone
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question