hello all...I'm new to this board
I have a PIX 10000 (yes i know, it's old) but I had purchased a correct card for use as a DMZ interface, when it boots up, its sees the card as an mcwa i82557 on IRQ 3
the inside and outside interfaces read the same except that one is on IRQ 10 and the other is on IRQ 11.
The Pix boots fine with no errors showing up through the console, but I'm unable to pass any traffic.
Is there a certain slot these cards need to be in or a right version of code that i need to run? I'm running 5.1(5)
with 32MB RAM and 2MB Flash.
As soon as I take out that third card, the pix is fine and operates normally.
I'm at a loss Can anyone help?
tia
I have a PIX 10000 (yes i know, it's old) but I had purchased a correct card for use as a DMZ interface, when it boots up, its sees the card as an mcwa i82557 on IRQ 3
the inside and outside interfaces read the same except that one is on IRQ 10 and the other is on IRQ 11.
The Pix boots fine with no errors showing up through the console, but I'm unable to pass any traffic.
Is there a certain slot these cards need to be in or a right version of code that i need to run? I'm running 5.1(5)
with 32MB RAM and 2MB Flash.
As soon as I take out that third card, the pix is fine and operates normally.
I'm at a loss
Can anyone help?tia