Adding Digital Circuit Packs for Digital Sets

[telco101]

I purchased (3) 24 port digital circuit packs to support (60)digital sets for a new call center. I've never installed cards in the Definity G3. Can I get some instructions/steps from the Definity Guru's? Your assistance is greatly appreciated.

 

[mikeydidit]

To make this easy on you installing the sets, i would look in the carriers and see if I could get 3 slots that are side by side. The command "li con carr 0??" will show you the available slots. Install the packs (just slide them in and click the tab) then test the board. The command would be "test bo 0???? sh r 3" would be the correct comand. Then wire away.

This will give you an example of what i am talking about.

list configuration carrier 7b                                          Page   2

                              SYSTEM CONFIGURATION

Board                                                     Assigned Ports
Number   Board Type              Code     Vintage    u=unassigned t=tti p=psa

07B13    DIGITAL LINE            TN2224CP HW03 FW015 01 02 03 04 05 06 07 08
                                                     09 10 11 12 13 14 15 16
                                                     17 18 19 20 21 22 23 24
07B14    DIGITAL LINE            TN2224CP HW05 FW015 01 02 03 04 05 06 07 08
                                                     09 10 11 12 13 14 15 16
                                                     17 18 19 20 21 22 23 24
07B18    DIGITAL LINE            TN2224CP HW08 FW015 01 02 03 04 05 06 07 08
                                                     09 10 11 12 13 14 15 16
                                                     17 18 19 20 21 22 23 24
07B19    ANALOG LINE              TN793CP HW04 FW007 01 02 03 04 u  u  u  u
                                                     u  u  u  u  u  u  u  u
                                                     u  u  u  u  u  u  u  u

This show the carrier to have packs in slots 13 and 14 but nothing else until slot 18.

Hell, there are no rules here - we're trying to accomplish something.
Thomas A. Edison

For the best response to a question, read faq690-6594

 

[simreal]

Depending on the release of the definity you may also need to add them to "change circuit x" before you can test the boards. X= the port network you're adding the boards to.

once they are are in and testing ok then you can simply wire the ports to the phones via whatever cross connect method you're dept uses.