Adding Dial Peer to VG and GK in IPCC environment

[jcs64]

We have an IPCC platform that was installed by our vendor who also scripted and migrated our existing call flows off our legacy Nortel platform. We now need to turn up a new project from scratch and I need some insight as to the vg and gk entries for the new toll free. I believe I know what to do on the vg by looking at the existing entries. That is a POTS and VOIP dial peer. However I am unsure of how to make the entries on the GK referencing the call to CVP. I have pasted below an existing example for inbound number 6546292.

VG

service 6546292 flash:6546292.tcl
param alert-timeout 15
param after-hours-agent0 DTMF*8,,,115
paramspace english language en
paramspace english index 0
param setup-timeout 7
param after-hours-agent1 DTMF*8,,,115
paramspace english location flash:
param after-hours-cvptime0 <10
param after-hours-cvptime1 >9

dial-peer voice 65462922 pots
description Survivability Trigger
service 6546292
incoming called-number 6546292
direct-inward-dial
port 0/0/0:23

dial-peer voice 6546292 voip
description primary 6546292 to GK
destination pattern 6546292
voice-class codec 1
session target ras
dtmf-relay rtp-nte h245-signal h245-alphanumeric
no vad

GK

zone prefix gk-phxaa01 654* gw-priority 10 phxcvp01 phxcvp02
zone prefix gk-phxaa01 654* gw-priority 9 saccvp01 saccvp02