adding channels of T1 for LD

[JacobNunley]

I get the following errors when i try and input the following commands

xxxxx(config)#voice-port 0/0/0:1
^
% Invalid input detected at '^' marker.

xxxxx(config)#dial-peer voice 999000199 pots
xxxxx(config-dial-peer)# service mgcpapp
xxxxx(config-dial-peer)# port 0/0/0:1
^
% Invalid input detected at '^' marker.

thanks

 

[jeter]

post a config so we can get a better understanding!!!!

General speaking a T1 resides on a Serial Interface for example look at this PRI setup


!
controller T1 0/2/0
framing esf
linecode b8zs
pri-group timeslots 1-24 service mgcp
description PRI 60.IPZX.397629
!


interface Serial0/2/0:23
no ip address
isdn switch-type primary-ni
isdn incoming-voice voice
isdn bind-l3 ccm-manager
no cdp enable
!
!
!
voice-port 0/2/0:23
!





Some people are like slinkies. Not really good for anything but they bring a smile to your face when pushed down the stairs.


Tek-TIP Member 19,650

 

[JacobNunley]

here is an config of a site that im using extra channels from the T1 for LD. this is at a site that is working just fine.

interface Serial0/0/0:0
description ********* 768k MPLS Circuit *********
bandwidth 768
ip address xxx.xx.x.xxx 255.255.255.252
service-policy output sprint-cos

control-plane
!
!
!
voice-port 0/0/0:1
!

dial-peer voice 999000199 pots
service mgcpapp
port 0/0/0:1
!
!

 

[JacobNunley]

I think i just figured it out.

on the router in question i had the following


controller T1 0/0/0
framing esf
linecode b8zs
cablelength short 133
channel-group 0 timeslots 1-12


but I need to add

ds0-group 1 timeslots 13-24 type e&m-winkstart