Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Adding bleed in framemaker
- Thread starter EBP1
- Start date
If you want to bleed a graphic off the page, create a graphic frame (middle of graphics tool set) on the Master Page that has an edge or two off the "page". Any element or color that's placed inside this frame bleeds off the edge.
However, if printing to most laser printers, these printers don't print closer than .63cm (1/4inch) to an edge of a physical page. Therefore, you will see white space as a border on your laser printed page.
If you do have a printer that supports full bleed, then this solution should work okay.
Dennis Dennis Hays, Publisher
However, if printing to most laser printers, these printers don't print closer than .63cm (1/4inch) to an edge of a physical page. Therefore, you will see white space as a border on your laser printed page.
If you do have a printer that supports full bleed, then this solution should work okay.
Dennis Dennis Hays, Publisher
- Status