Adding an analog VIC2-4FXO card to Cisco BE6000 config help

[Bahamian1977]

Good day, I am trying to configure a VIC2-4FXO card in a Cisco 2901 router so we can have our long distance calls go out over loop-start Vonage type boxes.I have added the 4FXO card to slot 0/1/0 as there is already a T1 interface in slot 0/0/0 for local calls and am now trying to figure out the config needed to add in the router for this new card. I have attached the config below. Any help would be greatly appreciated.

 

[whykap]

Since the router is registered to call manager using mgcp there is nothing to configure on the 2901 itself.
You just need to configure the new fxo module in call manager. Add it to the gateway configuration in call manager and configure each port you need active.
Then create a route group, route list, and modify the long distance route patterns to use the new route list you just created.