adding an additional 3304st to a 3002 concentrator

[kida]

I need to add an additional 3304st to my synoptics lattisnet 3002 concentrator....

I'm sure this isn't but... why not ask.. is it hot pluggable - do I need to power down?

Also... Do I need to do any reconfiguration of the NMM or will it accept the card just by plugging it in?

Thanks

 

[jimbopalmer]

It has been some time since I was adding cards to my 3000s, but as I recall it is hot swappable electrically, but new cards are not recognized until it rebooted, in fact as I recall it DID reboot. (I always argued that while my equipment might be hotswappable, my technicians weren't, so lets give them every safety precaution)

I tried to remain child-like, all I acheived was childish.