Adding a tab to ssTab

[achmo]

hello,

I want to add a tab (at design time) to an sstab, the new tab should be in between two exising tabs and not just at the end of the sstab. How do I do that?

Thanks for helping a newbie...

Yael

 

[Stretchwickster]

To add the tab:

SSTab1.Tabs = SSTab1.Tabs + 1

As for where it is positioned I am unsure.


Clive

http://www.kucu.co.uk

Ex nihilo, nihil fit (Out of nothing, nothing comes)

 

[Stretchwickster]

Check out: thread222-559316
I think it answers your question or will give you more information about using SSTabs anyway.

I've read in several places that it might be better to use a tabstrip instead of an SSTab control.

Also a further tip: it is recommended that you place all the controls for each tab in a frame for flexibility and tab order purposes.

Clive

http://www.kucu.co.uk

Ex nihilo, nihil fit (Out of nothing, nothing comes)

 

[achmo]

thanks! I've read the thread, and it seems there is no way but the hard way - add tabs at the end of the sstab and start moving controls from tab to tab. Oh well...

 

[Stretchwickster]

I'm afraid so! Good luck! It's definitely worth using the frame technique tho

Clive

http://www.kucu.co.uk

Ex nihilo, nihil fit (Out of nothing, nothing comes)