Adding 880 DID's

[Mnavickas]

No, not a typo need to add 880 total DID's to an IPO 8.1 Multi Site.
Programming 7 IPO's and the Headquarters of this SCN carries the PRI. All 7 sites have their own unique range (Site1: DID 73xx Extensions:73xx Site2: DID 74xx Extensions:74xx etc). Carrier is sending 4 digits.
When I use the MSN Config tool it does not bring up all the extensions of the other IPO's in the mesh SCN.

Is there a way to do this without MANUALLY typing all of them?

I had searched through older threads and came across one where they used only a few Incoming Call Routes set-up like this:
Received Digits -73xx Destination #
Received Digits -74xx Destination #
so on and so on for all 9 ranges.

Will that work?


Thanks in advance.

 

[intrigrant]

Why did you not look in the manager's help file. the answer is there.

A simple mind delivers great solutions

 

[tlpeter]

Yes that will work.
But like Intrigrant mentioned, it is in the help files.


BAZINGA!

I'm not insane, my mother had me tested!

 

[hairlessupportmonkey]

Below examples in F1 - Help

If you use # as your destination, it will redial the incoming number via your specified line group.


Example 5

In this example the digits 77 are received. Both the additional incoming call routes are potential matches. In this case the route with the shorter Incoming Number specified for matching is used and the call is routed to Services.

Line Group
Incoming Number
Destination

0
98XXX
Support

0
8XXX
Services

0
blank
Main




Example 6

In this example two incoming call routes have been added, one for incoming number 6XXX and one for incoming number 8XXX. In this case, any three digit incoming numbers will potential match both routes. When this occurs, potential match that was added to the system configuration first is used. If 4 or more digits were received then an exact matching or non-matching would occur.

Line Group
Incoming Number
Destination

0
6XXX
Support

0
8XXX
Services

0
blank
Main




ACSS - SME
General Geek