Add-TACSU

[RICHTz]

Greetings, I found this command on HiPath 4000 V3

ADD-TACSU:1-4-67-4,,1,1,0,0,30,1,1,,,0," ",250,250,2,1,EMPTY,0,NONE,NONE,0,EC&G711&G729OPT," ",0,GDTR,0,,Y,TC,ANMOSIG,0,222,0,0,1,1,1,0,MOSIG-DTMF,0-0,0;

how this command is executed without enter the number of the trunk group on the parameter TGPR,

what is mean??

Thanks

 

[sbcsu]

On older versions the parameter TGPR (Trunk Group/BUEND) was not essential.
This is because a Trunk Group was only required for OUTGOING calls, the TACSU you have is for Incoming only.

Now on newer systems you have to assign a BUEND to a TACSU even if it is for incoming only.
If you assign TGRP=0 to your TACSU you can do the same thing

 

[RICHTz]

Thanks SBCSU for your support,

can i ask you for this below commands whats are used for :

(1) CHA-DTIM1:STN,5,????;
(2) CHANGE-DATE:,,,,,,,0;
(3) CHANGE-ASSGN:SATIC,DPT4,CFILE,"C-FBTHIST",70000;

Thanks Again.

 

[sbcsu]

Hi,
Open ComWin/Expert Access and log on to the HiPath
Click on Macro and Retrieve System Variant, now the ComWin/Expert Access knows what version of HiPath you are using.

Then type in CHA-DTIM and then press CTRL and TAB (Tab is above CAPS LOCK)
This will open the MML editor
All of the commands that are relevant for that version of HiPath will be shown.

Also there are PDF documents of all the AMO's in the tondio server which you know of I think.

CHA-DTIM1:STN,5,????; This command comes up as an error - just ignore
It is to do with 'display fade in time for an incoming call'

CHANGE-DATE:,,,,,,,0;
This is to set the time zone offset in minutes (not all countries/territories have exact times in relation to one another - some are 3/4 of an hour ahead of neighbors etc.)

CHANGE-ASSGN:SATIC,DPT4,CFILE,"C-FBTHIST",70000;
Call Charging (CDR)- this sets up a circular file of length 70000 bytes on the hard disk to store call records if the records are not being output in real time.

 

[RICHTz]

Greetings,
I have OS4K V7 R2.23.3 duplex system,
i hava digital extension number=900 and analog station number =199
if 900 call 199
the 199 phone screen is appear the number 900 and on the second line of the screen (name) appear 0
for all phones which not give name on persi its clip appear with 0 why !!!!!!!!!

 

[sbcsu]

From your example you are ringing the Analog phone, I presume you mean to ring the Digital phone ?
Is the calling phone setup as SSTNO - secret station ?

 

[RICHTz]

no, its simple call between 900 as digital station and 199 as analog station,
on analog station screen if i dont defined any name for station 900 its appear like that
900
-- 0
the second line which appear name its appear 0 if i put any name for station 900 its appear rather than this 0,
at all phones like that