add t/n key codes

[1brc]

I have key codes for an Opt. 11 to ad t/n licensing, how do I enter them? I am not supposed to have to sysload after entry.

 

[PERRYPJ]

LD 143 UPGRADE OPTION, I WOULD FIND THE PRACTICE AND GO OVER IT BEFORE YOU START

OLD ROLMEN WORKING ON NORTELS

 

[1brc]

PERRYPJ, I looked up the upgrade procedure in ld 143 and going thru it looks like a system restart will happen after the key codes are installed. The paper with the codes on it says "No system restart needed" I can't take a chance on the system going down. Do you know for sure what will happen?

 

[hawks]

I have done it once before and did not have to reload the system. But if you are worried about it then I would do it after hours.

 

[1brc]

Thanks, I think I'll do that. That's what overtime is for.

 

[PERRYPJ]

IF YOU JUST DO THE KEYCODE SECTION THE SWITCH DOEN'T REQUIRE A SYSLOAD OR AN INIT

OLD ROLMEN WORKING ON NORTELS

 

[unkalary]

Make sure you are on TTY 0 when you go to LD 143..Only place it will work

 

[1brc]

That's a problem. see my other thread, I can't build tty o.