Add more GSM lines

[wofoster]

Hello:

I´m admin of a MD110 PBX in BC12.
Recently we add new users and the traffic were increassed. We use for celular traffic 2 GSM FCT analogical and we want to add 2 more gsm.

What command can i use to know if i can add more gsm and if its posible, how can asign new analogical exits for conects the gsm?

Kind regards

 

[Monrovia]

Hi
GSM FCTs (analog lines) are connected to TLU11 trunk boards.

To check the status of the trunk board,

SYEDP:LIM=XX,EQU=XX-XX-XX-XX,BPOS=XX-XX-XX; one of this LIM, EQU or BPOS has to fill up in this command, which will give you the detailed list of used trunks.

BR
Monro

 

[wofoster]

Thanks for the question:

I have enter the command and i have this result:

[resume results]
...
This is 4 analogical lines RTB
001-0-40-00 79 TL11 11/001-01
001-0-40-01 79 TL11 12/001-01
001-0-40-02 79 TL11 13/001-01
001-0-40-03 79 TL11 14/001-01
And here i have the gsm:
001-1-22-00 76 TL11 4/001-01
001-1-22-01 76 TL11 4/001-02
....
I discover the command SYEVP:TYPE=TL11 and also i have these results:
SYSTEM EQUIPMENT VACANCIES
EQU BOARDID
001-1-22-02 76
001-1-22-03 76
001-1-22-04 76
001-1-22-05 76
001-1-22-06 76
001-1-22-07 76

I think i have 6 more analogical EQU free, but i´m a junior admin and I dont the commands to trunk the EQU free to the new GSM.

It is posible to make an example of configuration?

Thanks,

 

[5755g]

hi to monrovia and wofoster i think you can asign new trunk line with
roeqi:rou=x,tru=x-x,equ=x-x-x-x;

 

[Monrovia]

ok fine. The remaining trunk ports on the same TLU11 board is free.
001-1-22-00 76 TL11 4/001-01
001-1-22-01 76 TL11 4/001-02
001-1-22-02 76
001-1-22-03 76
001-1-22-04 76
001-1-22-05 76
001-1-22-06 76
001-1-22-07 76

connect the FCT lines to these two trunk ports:
EQU BOARDID
001-1-22-02
001-1-22-03


Then enter the commands :

ROEQI:ROU=4,TRU=1-03,EQU=1-1-22-02;
ROEQI:ROU=4,TRU=1-04,EQU=1-1-22-03;

BR
Monro