We are using Arcserve 11 and a Dell Powervault to perform backups to "virtual tapes" (directories), then performing a tape-to-tape copy to put the backup onto actual tapes.
I'm not forcing compression on the virtual tape (something I may institute soon). As a result, the tape to tape copy is copying data that isn't compressed.
is there a way to force compression during this copy phase? I don't see a flag in the manual that would allow this...
Thanks in advance for any help.
I'm not forcing compression on the virtual tape (something I may institute soon). As a result, the tape to tape copy is copying data that isn't compressed.
is there a way to force compression during this copy phase? I don't see a flag in the manual that would allow this...
Thanks in advance for any help.