Adaptec 3200S RAID Card - Cluster Enabled.

[urbex2013]

Hi, I have a server which has an Adaptec 3200S RAID Card installed.

After the RAID card has completed its POST it says, "Cluster Enabled !!!" "Hit <CTRL+A> for Adaptec Setup.

After Ive pressed CTRL+A to access the admin side of the card, how do I disable the cluster enabled setting ?

Any advice would be much appreciated.

M.

 

[FredWagner]

You'll have a better chance of expert answers if you post this in the IBM Disk and RAID solutions forum over in the Server Rack section of this site....

Fred Wagner

 

[rclarke250]

I don't see in the users guide or installation guide where to turn that option off, you may have better luck sending an email or asking on Adaptec support website.