ACS 6.0 Caller ID clock issue 1

[52rich]

I have a ACS 6.0 with 2 ea 308EC boards and 8 CO lines wired from a service providers T-1 Adtran.The service provider is just giving me 8 POTS lines out of his Adtran..No T-1 card in my system. My issue is that the clock display on my sets is incorrect by sometimes hours and the date stamp is off by months at times.I have seen clock time affected in the past on other systems but never a date change by months!!. I have changed both with # 101 & # 103 but while observing incoming calls it seems the clock change MIGHT be coming from the service provider. I'm familiar with # 128 in the 7.0 and 8.0 systems but I have never seen this within a 6.0 where not only the time but the date goes incorrect...I will try to return to the site tomorrow to really watch the incoming calls to see if in fact it's the cause.
Can anyone confirm that the caller ID time date stamp can affect a ACS 6.0 time clock change...Should I try to do a # 126 and deactivate the automatic daylight savings or just cancel the caller ID with the service provider.The system had to be powered up and down several times today..Possible cause?? Hmmm.
Thanks

 

[Dexman]

I think the answer was posted in another topic. The clock chip inside the processor is bad. My thought would be to back up the programming to the PCMCIA card (if one is present) and replace the processor.

Unlike the R7 & R8 processors, the time stamp sent along with Caller ID info isn't used by the R6 processor to adjust the clock, so no harm in keeping that service.

I "FEATURE 00"

 

[52rich]

Dexman...Thanks for the reply...I suspected that, but was not really sure if the 6.0 clocked off of the caller ID...
Thanks for your input and putting my mind at ease...
A star for you!

 

[Dexman]

Thank you for the star!

I "FEATURE 00