Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Accessing page route on sbo from cs1000

Status
Not open for further replies.

andkas

IS-IT--Management
Nov 28, 2008
25
US
I have a page route setup on a SBO with an ACOD of 6003. I am trying to dial that access code from our CS1000 over a sip trunk.
If I have 6003 on an analog set on the SBO I could dial 6003 from the CS1000. This is the page route on the SBO

TYPE RDB
CUST 00
ROUT 25
DES PAGE
TKTP PAG
NPID_TBL_NUM 0
NACC PGNR
ESN NO
VTRK NO
NODE
ICOG OGT
SRCH LIN
STEP
ACOD 6003
TARG 01 08
CLEN 1
OABS
TIMR ICF 512
OGF 512
EOD 13952
DSI 34944
NRD 10112
DDL 70
ODT 4096
RGV 640
GRD 896
SFB 3

IENB 5
TFD 0
SST 5 0
NEDC ETH
FEDC ORG
HOLD 02 02 40
SEIZ 02 02
RGFL 02 02
CDR NO
MUS NO
TTBL 0
OHTD NO
ALRM NO
ART 0
SGRP 0
ARDN NO
AACR NO
 
When I try to access teh Page route I get a fast busy release and try again
 
Change the prompt NACC (network access control) from PGNR to PGNU, Paging restricted to paging uncontrolled

 
I think it maybe the TARG - 1. Default on the sets of the CS1000 have tgar of 1. This maybe restricting the sets from dialing the access code.


Avaya/Nortel/NEC/Asterisk/Access Control/CCTV/DSX/Acti/UCx
 
Thank you kstaff2,
It was the PGNU.

Fow noow I have the No TARG.
I get the the following error DCH 9 IMSG SETUP REF 00008181 CH 252 0 0 0 TOD 9:21:26
FEAT :CRID
FEAT :NAS
FEAT :NCID
PROGRESS: CALL IS NOT END TO END ISDN
CALLING #:2174 NUM PLAN: PRIVATE/ABBREVIATED (CDP)
CALLED #:6003 NUM PLAN: PRIVATE/ABBREVIATED (CDP)

DCH 9 OMSG REL COMP REF 00008181 CH 252 0 0 0 TOD 9:21:26
CAUSE :SRV OF OPTION NOT ALLOWED
DIAG: 093
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top