Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Access to trunk

Status
Not open for further replies.

joeban

Technical User
Sep 28, 2002
74
US
I have the need to allow all users to dial access code to a Tie trunk between 2 PBX's. At this point some users can and some cannot. There is no way of changing all users phones the NCOS. Is there a way of doing it on the trunk?whwere can I go to program it?. Thanks in advance.
 
Ihave changed the TARG in RDB to 0 and I tried to dial the trunk access code from a phone that is restricted and it still did not work.
I have noticed the phone that I can have access to the trunk it has TGAR 0 and NCOS 4
The phone that I cannot dial from The TGAR is 1 and NCOS 4
 
Did you x other entries, as you can have multiple? It's not a chg really, x whatever is in there besides 0 on the route.

Mato' Was'aka
 
I am sorry I went and changed in LD 16 but when I went to Ld 21 to print the route again to check it is still TARG 01 and not 0. I dont know why it did not take the 0. Am I doing somthing wrong by not allowing me to change?. Any inputs will be greatly appreciated
 
Did you X TARG 1 on the RDB for that Route?

LD 16
REQ CHG
TYPE RDB
CUST 0
DMOD
ROUT ?? enter the Number for your Tie route


TYPE RDB
CUST 00
DMOD
ROUT 1
DES ANALOG
TKTP COT
NPID_TBL_NUM 0
PRIV NO
SAT NO
RCLS EXT
DTRK NO
ISDN NO
PTYP ACO
AUTO NO
ICOG IAO
RANX NO
SRCH RRB
TRMB YES
STEP
ACOD 8001
CPP NO
TARG 01------------------X1
CLEN 1
BILN NO
OABS
TIMR ICF 512
OGF 512
EOD 13952
DSI 34944
NRD 10112
DDL 70
ODT 4096
RGV 640
FLH 510
GRD 896
SFB 3
CRD 512


PAGE 003

TFD 0
LEXT 100
SST 3 0
NEDC ETH
FEDC ORG
CPDC NO
SPCT IMM
HOLD 02 02 40
SEIZ 02 02
RGFL 02 02
RVSD 08 31
ILLR 02 02
DRNG NO
CDR NO
MUS YES
MRT 9
MR NO
RACD NO
MANO NO
EQAR NO
FRL 0 0
FRL 1




This is an Analogy so don't take it personally as some have.

Why change the engine if all you need is to change the spark plugs.


 
Thanks for all your help. It did it by x01.
 
I hit the Submit button by mistake.

Whenever a TARG On the Trunk and TGAR on the Set match the call is denied.

LD 16
REQ CHG
TYPE RDB
CUST 0
ROUT ?? enter the Number for your Tie route
TARG X1





This is an Analogy so don't take it personally as some have.

Why change the engine if all you need is to change the spark plugs.


 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top