Access to Server in the DMZ 1

[rangerman]

I am just trying to get to grips with this ASA firewall and would be gratefull for some help advice - I am going to go away and do some reading this weekend - this seems simple enough to do but I struggling - so please bear with me.

I have a server in the DMZ area with an IP of 172.*.*.* for example and I need to transfer files to it but cannot - for obvious reasons.

I have managed to get and RDP to it from my machine but I am unable to transfer some files to it - am I going mad here or should I be using some software to transfer the files ?

Will i need to put in access rules to allow me to get to the c: drive ?

I am on a 10 .*.*

thanks

 

[unclerico]

post a scrubbed config.

I hate all Uppercase... I don't want my groups to seem angry at me all the time! =)
- ColdFlame (vbscript forum)

 

[Supergrrover]

Take a look at this doc. It gives a thorough run down -

http://www.cisco.com/en/US/products...s_configuration_example09186a00806745b8.shtml

This gives a good foundation for allowing traffic -

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a0080862017.shtml

Brent
Systems Engineer / Consultant
CCNP, CCSP