Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Access paging through Auto Attendant??

Status
Not open for further replies.

thephonelady

Vendor
Feb 27, 2004
479
US
My customer wants to access their paging system using the AA at night. I'm not sure if this can be done. I don't have the system available to me to try setting it up, but I did create an offline config and was not able to program a selector code to access 70. Any ideas?? System is in Basic/Partner mode, sold and installed by their former vendor.
Thanks in advance.
 
Think you'll need to have a singe line extension ring into a "Centrex" paging adapter, which will answer the ring and connect the audio to the input of the paging amplifier. The caller would dial the extension number or a selector code that points to the extension number, wait for the paging adapter to answer, then make their loudspeaker page
 
A Bogen TAMB2 connected to an analog station should do the trick. We use them for internal paging but I can't see why it wouldn't work. AA transfers to the assigned extension, it rings, TAMB2 picks up, gives a tone and start talking. It is single zone, doesn't require any DTMF input.


Dermis and feline can be divorced by manifold methods.*
*(Disclaimer for all advise given)--'Version Dependent'
 
Ip500 basic auto system answer?
I am replacing all of my partner systems with the IP500 basic, one customer has a ASA card installed, she uses this when there are too many calls to get to.
Is there a way or work around to emulate this feature on the IP500 ?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top