access code for two defrent PRI

[3mran]

hello

i have Nortel cs1000 with two defrent PRI from defrent service provider right now the existing configuration 9 it will take from first PRI loop , now how to add a new acces code to take an DID from the second PRI with two or three digit number but this setting i need it for an analog sets , i am really straggling with it .

 

[Firebird Scrambler]

There are a number of ways to do this, the easiest and probably the quickest way is to just have the access code set to whatever digit's you want to use that doesn't conflict.

Against the route that you have provided for your new DID channels, make sure that the default TARG setting of "1" is removed and change it to a spare number such as "2" etc.

Your analogue sets should be able to select the new DID channels, assuming that their TN's TGAR is set to the default of "1".
However, this means that all your other extensions might still be able to access the new channels if their TGAR isn't set to "2" etc.

Generally speaking, any matching TGAR and TARG should prevent the ACOD from being dialled for a given route. You might have to check out all of your extensions which could take a while and also check the TARG setting for ON/OFF in LD 86 under ESN.

Another way is to see under ESN if the AC2 code is being used and if it isn't to add in a access code and to program a new RLI in the same way as the AC1 setup, but only as a AC2 entry.

Firebird Scrambler

Nortel & Avaya Meridian 1 / Succession & BCM / Norstar Programmer

Website =

http://somertel.com

linkedin