When I run Access 97 on NT4 I get the error msg "Disk Or Network Error" - OK. Then a message telling me that there is not enough memory to run access 97. I have 128Mb. Can any one help. Thanx Dave Shaw!
pls chaeck underadvanced tab of system icon in control panel. click "Environment Variables" and see if TEMP and TMP variables are setup. if they r not, then click New and add the two variables. the values ca be set to C:\TEMP and C:\TMP
under win explorer make sure there r folder with those names, if not create them.
if they exist under "Environment Variables" then make sure the paths mentioned are valid
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.