Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

accelar 1200 problem

Status
Not open for further replies.

TDN2007

Vendor
Apr 10, 2008
49
JO
Hi all,

i have an accelar 1200 trying to maneget it, but when i turn on it seems it does not boot correctly.
give this in the hyper terminal session:
Accelar Monitor v2.0.5

CPU: 60Mhz PPC 403GCX Type 2 Rev 1 in Slot 5
DRAM: 32M
Chassis: 1200
Reason for Last Reset: WDT
Power supply 2 not present

monitor>


and stuck there.
it does not continue to the log in file.

i want to know why is that happen.
is there any thing to do with this.

note: i have no pcmcia card connected to XLR1298SF

best regards

 
It looks like your at the boot monitor prompt. You'll need to boot the software agent, assuming you have the software code on the flash (trying a "dir") you could boot it with the following command, "boot /flash/p12a1000.img"

Good Luck!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top