Accelar 1200 configuration question

[Hud18]

I'm trying to setup an IP in my Accelar 1200, I think I have done most of it successfully because when I do:
SHOW IP ROUTE INFO

I get:
Dst Mask Next Cost Vlan
136.18.32.0 255.255.254.0 136.18.32.4 1 1

However, I cannot ping the device or remotely manage it.

What am I doing wrong?

 

[JavierBS]

Try this:

show vlan info bas
show vlan info ip

config vlan XX ip create <ip/mask>. The IP must be of the same segment of your network...

 

[Wookie27]

Also make sure that the port your pc is connected into is is a member of that Vlan.. the &quot;show vlan info all&quot; command will be able to tell you this.