Hey Guys,
I am using an Extreme Summit 200-48.
SW Version 7.3
I configured 10 VLAN with 2 untagged ports for each VLAN.
I am able to block all traffic ( TCP,UDP,ICMP...).
(I did this via the Web Interface)
No I want to configure that some VLAN´s can talk to another VLAN, but not more. Can´t find a setting in the WebInterface. I takes all ports.
How to setup such an ACL on the console ? The Access-Mask should look like : ACMName, Vlan, IPprot, Precedence (correct )
Can somebody give me an example how this scenario would work?
VLAN1 (Port 1,2) is allowed to talk to VLAn2(Port3,4) but is NOT allowed to talk VLAN3 (port5,6)
thx
Christian
I am using an Extreme Summit 200-48.
SW Version 7.3
I configured 10 VLAN with 2 untagged ports for each VLAN.
I am able to block all traffic ( TCP,UDP,ICMP...).
(I did this via the Web Interface)
No I want to configure that some VLAN´s can talk to another VLAN, but not more. Can´t find a setting in the WebInterface. I takes all ports.
How to setup such an ACL on the console ? The Access-Mask should look like : ACMName, Vlan, IPprot, Precedence (correct )
Can somebody give me an example how this scenario would work?
VLAN1 (Port 1,2) is allowed to talk to VLAn2(Port3,4) but is NOT allowed to talk VLAN3 (port5,6)
thx
Christian