about error information

[Wesleywoo]

please help me.in my system has this error information please give me some suggestion:

like thisTA224 40 20

DTA224 40 21

DTA224 40 30

DTA224 41 16

DTA224 41 30

DTA224 56 4

DTA224 56 27

DTA224 56 29

DTA224 56 30

DTA224 57 11

DTA224 57 27

DTA224 57 29

DTA224 57 30


IG_CONT
CONT END
INTRA CONT START DTA224
INTERLOOP TEST START.
DTA224

this error reports every five minute.but I don't what's wrong with my system and my system is nortel option 81c.

thanks everyone!!!!

 

[mikeyb123]

DTA0224 loop ch
DTI loop audit has found channel (ch) to be in an invalid
HALFDISCONNECT state (trunk lock-up). An disconnect attempt is being
made on the CHNL.

Severity: Minor

It's not getting any smarter out there. You have to come to terms with stupidity, and make it work for you.

 

[johnpoole]

might try ld 80 trad x x on the loops and channels. ld 60 stat before hand (ld 60) to see what t's are busy or fe mbsy, your missing a disconect. either ndec or fdec needs tweaking and check suprvision prompts, might have a yes where you need a no

john poole
bellsouth business
columbia,sc

 

[Wesleywoo]

I have try it,this is the trad information:

trad 57 30

ACTIVE TN 057 30
ORIG 057 30 TIE RMBR 0 120
TERM NONE
DIAL DN 6246
MAIN_PM HALFDISC
TALKSLOT NONE
EES_DATA:
NONE
QUEU NONE
CALL ID xxxx 16644


---- ISDN PRA CALL (ORIG) ----
CALL REF # = 15744
BEARER CAP = 3.1KHZ
HLC =
CALL STATE = 6 PRESENT
CALLING NO = xxxx1316 NUM_PLAN:E164 TON:SUBSCRIBER ESN:NXX
CALLED NO = xxxx6246xxxx6133xxxx6095 NUM_PLAN:E164 TON:SUBSCRIBER ESN:NXX

please help me see this information what's wrong.and what can I do?

thanks johnpoole

 

[T1PSTN]

What type of system is this tie going to? Another Nortel? Also, what flavor of PRI are you running... DMS, NI2, SL1, etc.?

You may have a configuration mismatch with the far switch. If it does go to another Nortel, try comparing the RDBs and trunk members, making sure that the signaling and starting arrangements agree.

I've gotten stuff like this before... When trying different tie-line builds for a Cisco router. The issue always resolved when I made sure that the configuartion on both sides agreed.

Look at DSEL and SIGO in the RDB and STRI, STRO on each trunk member for starters.

I think that a half-disconnect signifies that one side of the link is trying to release the call, and the other won't acknowledge the disco.

--T1PSTN