aar analysis and forcing the call

[manek]

Hi,

can you somebody to help? We have S8700 multivantage on 2 sites, call them site 1 and site 2. Both sites are connected by ISDN-PRI (route pattern 80) and on every site is arranged extension number 800, but when is public call 603600800 comming to the site 1 I want to him to go to the site 2. So I have set in incoming trunk on site 1 that call is going to the aar at first. But I can´t force it to go to the site 2. AAR is set as follow :

AAR DIGIT CONVERSION TABLE
Matching Pattern 800,
Min 3, Max 3, Del 0,
Replacement String,
Net aar, Conv n, ANI Req n,
------------------------------------------------------
AAR DIGIT ANALYSIS TABLE
Dialed String 800, Total Min3 Max3,
Route pattern 80, Call type pubu, Node num,
ANI Reqd n,

Thanks for help.

 

[1a22ip]

Try UDP table to a aar route for the extension you want to go to the other site. Make a route with trunk group 80 as the first choice. Then in the uniform dial plan "point" the extension to a AAR code. In aar analysis point the aar code to the route you created. Examples are below I point all extension that start with 2 to another site:
UNIFORM DIAL PLAN TABLE
Percent Full: 0

Matching Insert Node Matching Insert Node
Pattern Len Del Digits Net Conv Num Pattern Len Del Digits Net Conv Num
2 5 1 332 aar n
now the aar table:
AAR DIGIT ANALYSIS TABLE
Percent Full: 34

Dialed Total Route Call Node ANI
String Min Max Pattern Type Num Reqd
332 7 7 200 aar n
Now the route:
Pattern Number: 200 Pattern Name:

Grp FRL NPA Pfx Hop Toll No. Inserted DCS/ IXC
No Mrk Lmt List Del Digits QSIG
Dgts Intw
1: 7 0 2 n user

Works Well
ED

1a2 to ip I seen it all