A1000 RAID Controller fails to start

[MDatHome]

Hello all,

I have got a used A1000 RAID rack and it worked for about 2 days then it stoped to work after a power failure.
I have connected to the serial line on the back to see whats happening.

It starts but ends with some warnings
and then nothing happens.

Send <BREAK> for shell access or baud rate change

.WARN: RPA Memory parity error detected
WARN: Suspending Start-Of-Day Task
...NETWORK ERROR: Unable to access BOOTP server
WARN: NCM Init Failure: Network is not initialized

Do I need to replace the RPA memory or is it a Controller failure ?

/MDatHOME

 

[SamBones]

There are some little internal batteries that help save the configuarion information. Since it happened after a power failure, they are high on the suspect list. You should probably track down and change those first.

Hope this helps.

 

[MDatHome]

The battery is replaced now but the fault remains.
Any more ideas ?

/MDatHome