Hello all,
I have got a used A1000 RAID rack and it worked for about 2 days then it stoped to work after a power failure.
I have connected to the serial line on the back to see whats happening.
It starts but ends with some warnings
and then nothing happens.
Send <BREAK> for shell access or baud rate change
.WARN: RPA Memory parity error detected
WARN: Suspending Start-Of-Day Task
...NETWORK ERROR: Unable to access BOOTP server
WARN: NCM Init Failure: Network is not initialized
Do I need to replace the RPA memory or is it a Controller failure ?
/MDatHOME
I have got a used A1000 RAID rack and it worked for about 2 days then it stoped to work after a power failure.
I have connected to the serial line on the back to see whats happening.
It starts but ends with some warnings
and then nothing happens.
Send <BREAK> for shell access or baud rate change
.WARN: RPA Memory parity error detected
WARN: Suspending Start-Of-Day Task
...NETWORK ERROR: Unable to access BOOTP server
WARN: NCM Init Failure: Network is not initialized
Do I need to replace the RPA memory or is it a Controller failure ?
/MDatHOME