Hi All,
Here’s one, I can’t even begin to work out what to do, but nevertheless I’d love to be able to do it.
I have written an Access 2000 application that is designed to run best in 1024 * 768 resolution, however the users tend to have resolutions all over the place.
(Assuming all monitors can handle the resolution)
So my question is, is there a way when the access application is loaded it will
a) Make a note of the existing resolution
b) Change the resolution to 1024 * 768 as the application starts
c) Change back to the existing resolution when the application quits
Any help on this, or if anyone has any code to do this, I would be really grateful
Many thanks
ModeX
Here’s one, I can’t even begin to work out what to do, but nevertheless I’d love to be able to do it.
I have written an Access 2000 application that is designed to run best in 1024 * 768 resolution, however the users tend to have resolutions all over the place.
(Assuming all monitors can handle the resolution)
So my question is, is there a way when the access application is loaded it will
a) Make a note of the existing resolution
b) Change the resolution to 1024 * 768 as the application starts
c) Change back to the existing resolution when the application quits
Any help on this, or if anyone has any code to do this, I would be really grateful
Many thanks
ModeX
