Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

A realy newbe question about programming a BP250 with BMS.

Status
Not open for further replies.

Rob-TdF

Technical User
Jun 13, 2018
1
AR
Hi everyone.
I use to work with an old Harris/Teltronics 2020, and now after a working relocation, I´m in the new (and unknown at least for me) BP250´s world, and I´m trying to do through BMS some mods.
Basicaly, I already did some simple changes to the extensions (COS and so), and until there, all fine.
This BP250 has an analogic trunk with eight lines and a CAS with 30 channels (322100 to 322129) and of course the extensions 2100 to 2129 are linked to the channels (DTA in the Harris/Teltronics).
I have been asked to let the extension 2109 to use the channel 322105 instead of the 322109 to do the outgoing calls.
Is that posible? If so, can it be done through the BMS?
I was seeing in detail the BP250 configuration in the BMS, and I have seen the TCD table, the traffic groups, traffic groups members, but I can not figure how to do that.
Does anybody can give som tips?
Thanks in advance.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top