Hallo,
I am using Inventor 10 for my 3D modelling.got a small problem, Hoping that i would get any answer asking you people in this forum.
i have done an assembly of around 20 parts, named it as assembly.iam. Now i want this assembly to be used in other Project which has no relevance to this project.
i need this assembly as a block so that i can use it again and again. i have tried as STEP and SAT but as i insert these files, it show me as an assembly with parts but not as a block.
i want it to be a single block where in its impossible to see the ipt's (parts).the whole iam should become as a single ipt or block.
is there any method in doing like this.
thank you in advance,
Singoi
I am using Inventor 10 for my 3D modelling.got a small problem, Hoping that i would get any answer asking you people in this forum.
i have done an assembly of around 20 parts, named it as assembly.iam. Now i want this assembly to be used in other Project which has no relevance to this project.
i need this assembly as a block so that i can use it again and again. i have tried as STEP and SAT but as i insert these files, it show me as an assembly with parts but not as a block.
i want it to be a single block where in its impossible to see the ipt's (parts).the whole iam should become as a single ipt or block.
is there any method in doing like this.
thank you in advance,
Singoi