A-number identifications

[Orim]

Hi all,
In thread CALLER ID I explain my problem.(look thread CALLER ID bellow).
AXE10 people said to me that I must set in MD110 type of number – Subscriber and MD110 must be set to send all number – 9171xxx, not only xxx.
How can I make this?
Thank you in advance!

 

[Jaydee2002]

Do you have any Public exchange numbers set up per lim as well as per route?
Any EXNPOU set up using the RODNI command will be overuled by a EXNPOU set up per LIM, if the call originates from a different LIM to the route.

You can check to see if they are set up with

ROELP;

I might be well wide of the mark with this but thats my understanding from reading Dynatext.


JD

 

[Orim]

Hi Jaydee2002
Thank you for reply,
This is the answer from ROELP.
NOT FOUND EXNOPU PER LIM

 

[baf]

I think it is necessary to make the following

RONDI:ROU=XXX,EXNOPU=0-9171;The type of number sent on the switchboard will be unknown. If your numbering three-value it is necessary to add figures up to necessary number. It is made.

 

[Orim]

Hi baf,
I tried this but nothing happened.

 

[baf]

send me, please, by email baf@koenig.mts.ru output of NADAP, RONDP, NUTRP, SUDIPIR=XXX. And what signalling with AXE10? Send me and I'll try to help you.

 

[Orim]

Hi baf,
I connected PA41 PRI analyzer equipment to monitor 2 Mbits and sow that our exchanges sent A-number. So it turned out that the problem is in AXE10. They changed something and the problem was fixed.
Thank’s baf for helping!