Running CM 5.2.1. I have 2 SIP phones set up as OPS stations and are registered to SES. Internal calling is no problem. When I call from the outside, Dial Plan Transparency is used and the call is re-routed to the DPT LDN and the call fails. Short of turning off DPT on every network region, I cannot find a way around this. Any thoughts?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
96xx SIP, IGAR/DPT
- Thread starter teej0820
- Start date
jimbojimbo
Vendor
DPT is a CM/H.323 feature and is not applicable to SIP endpoints. I am assuming you only have an SES at one site so all communication between the SES and any remote endpoint will need to be over the LAN/WAN.
- Status
Similar threads
- Question