9620 connection to cisco

[tfisher7us]

I have a customer that I am installing two 9620 vpn phones the have an ip500v2 10.0. I have already sent their IT guy the docs on how to set it up and then he asks me this question.

Tony,
I spoke with my distributor and cisco and they say as long as the phones you are using has IKE v2 client , they should be able to use anyconnect.. The anyconnect plus license is the type they said had to be enabled to allow for VPN phone setup. The license is advertised as being for Cisco vpn phones but they said as long as the phones held to that standard they should work. Please confirm if your phones can do this and I'll move forward with the upgrade and programming.

Do the 9620 use IKE v2 client?

 

[bob10752000]

Taken from Docs::

Third-Party Security Gateways interoperability limitations
Third-party devices by the following vendors interoperate with Avaya VPN phones and may have
certain limitations as per the note below:
• Checkpoint
• Cisco
• Juniper
• Nokia
• Nortel

Note:
Avaya does not guarantee compatibility with all security gateway devices or software provided
by a particular vendor, nor is every possible configuration of such devices supported. In general,
the following capabilities interoperate:
• Integrated IPSec VPN Client that supports these IPSec protocols:
- Internet Protocol Security (IPSec),
- Internet Key Exchange (IKE), and
- Internet Security Association and Key Management (ISAKMP)
• Pre-Shared Key (PSK) with or without XAUTH
• RSA (Rivest-Shamir-Adleman) signatures with or without XAUTH
• NAT traversal, and
• SCEP



ACSS (SME)
APSS (SME)

 

[intrigrant]

Google this : avaya vpn phone cisco
It has all the answers.