OK, here I get to really show my Norstar ignorance.
Yesterday I added a 12X0 trunk module and a 0X16 Station
Module. I cross connected the stations to the 66 block and
all appeard well, until this morning. Evidently the have Centrex lines and have to now dial 9 to get out, which is
ok by them but I did a set copy to add the new stations and it evidently didn't take or I didn't do it right.
So what is the easiest way to perform a set copy and what do I need to do to make sure that the additional modules
will work in key mode...
Thanks....
Yesterday I added a 12X0 trunk module and a 0X16 Station
Module. I cross connected the stations to the 66 block and
all appeard well, until this morning. Evidently the have Centrex lines and have to now dial 9 to get out, which is
ok by them but I did a set copy to add the new stations and it evidently didn't take or I didn't do it right.
So what is the easiest way to perform a set copy and what do I need to do to make sure that the additional modules
will work in key mode...
Thanks....
