8x16 MBM

[morgansdad]

Has anyone installed the new 8x16 MBM in a BCM400 4.0? If so, where did you find the dip switch settings? I am trying to install it in BUS#3. I have a 32+ in bus 2, 8x16 in bus 3 and a CTM8 in 6. If possible, could you post the dip switch settings?
Thank you....

 

[techman63]

This module is only supported on BCM50 release 2.

 

[morgansdad]

The Nortel BCM Configuration switch settings sheet that came with the MBM says, "Teh G8x16 is compatible with all BCM systems and with the BCM50 Release 2.0 systems." Any ideas?

 

[option11newby]

The dip switches are set exactly the same as a GATM module.

So for Bus3, On,On,On,On,On,Off (Offset 0)

The documentation states that this will actually use buses 3 and 4.

Country Profile dip switches left all OFF if system is 3.5 or above.

Hope this helps