8200N problem with black ink code 009.08.124.43

[alman67]

Hi i have problem with my Xerox 8200n with black ink stick. the priner start warm and of 90% begin from start and the led lamp on the control panel is blinking in red. On the self test im see the fault eror 009.08.124.43. On the oficial web site of Xerox this is problem with black ink. If somebody have any solution to the problem I will be glad to hear for the reason

Excuse me for my bad english
Thanks

 

[Michael52x]

Problem is related to the heater for the black ink. The jets may be clogged. Print a Light Stripe Test to see how many are clogged. You can use Jet substitution if there are only a few, but not three in a row. If this is the case, then replace the printhead. If the jet-stack is not heating properly, then it may be the power supply. Good luck

 

[CULTOFLON]

Is the correct error 9,008.43? If so then you have a problem with the black ink-melt heater. Check and make sure ink is able to advance in the chute. If the ink is advancing correctly replace the ink loader.