I have an 81c that has a Clock controller QPC471H in net grp 1 shelf 0 that is working fine. However the clock controller in net 1 shelf 1 is not working at all, when I try to enable (enl cc 1 fdl) it it give me a DTI068 that say "System clock generator is not responding" when I do ssck 1 it say UNEQ.I thought it might be the back plane so I swapped it and the cables out for a brand new ones that I happened to have. Still does the same thing. It's in slot 13 of the net shelf, and is set for cc 1 with the dip switches. Is there something I am missing in the programing. If it means anything I can't enable the conf/tds cards on either shelf.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
81c clock conlroller
- Thread starter Jigman32
- Start date
jimbopalmer
Programmer
To the best of my knowledge the 81C is a PBX, not networking gear.
Here is a forum about 81C
I tried to remain child-like, all I acheived was childish.
Here is a forum about 81C
I tried to remain child-like, all I acheived was childish.
- Thread starter
- #3
- Status
Similar threads
- Locked
- Question