Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

8110M Analog Set -No hold

Status
Not open for further replies.
MTCInc

MTCInc

Vendor
Feb 7, 2007
31
US
We have a few 8110M analog sets where the HOLD button and light will not operate. The speaker is supposed to cut out completely.
Have any technicians experienced this problem?
I was able to check the light and it is good.
Can anyone name the resistor number on the circuit board that may be bad or point me in the right direction?
Thanks
 
Status
Not open for further replies.

Similar threads

MGS_33
  • Locked
  • Question
Issue dialing a number with no hold conference (CM8) 1
Replies
2
Views
305
MGS_33
MGS_33
telm59
  • Locked
  • Question
Analog caller ID
Replies
1
Views
193
dialtonebone
dialtonebone
jh40
  • Locked
  • Question
Remote worker one-way talk after hold 1
Replies
3
Views
305
Arlo555
Arlo555
MohamedSami
  • Locked
  • Question
IPO analog incoming Prealerting issue
Replies
1
Views
145
mikeydidit
mikeydidit
Stinney
  • Locked
  • Question
Can't set SIP signaling group to not add '+' 1
Replies
2
Views
5K
Instructor of Avaya
Instructor of Avaya

Part and Inventory Search

Sponsor

Back
Top