Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

7920 and Very Loud Ringtones

Status
Not open for further replies.
Raymondo206

Raymondo206

IS-IT--Management
Joined
Jun 30, 2003
Messages
34
Location
GB
We are currently runing a number of 7920's in a factory environment. We are using the Cisco 'Loud' ringtones, volume set to max, and set to vibrate.

These however are still a bit quiet. Does anyone know of any really loud ringtones for the 7920.

Cheers

Ray
 
Sort by date Sort by votes
Do you use f/w 1.08? It has some extra loud ringtones. When you combine them with outdoor profile should be fine for most enviroments. AFAIK it is the maximum loudness due to some compliance regulations.

Regards
M.
 
Upvote 0 Downvote
Yes we have just updated the FirmWare to 1.08.

We are using the outdoor profile.

The only loud ringtones we have is
Loud Laser
Loud Classic ring 1
Loud Analogue Synth 1
Loud Chirp 1
Loud Chirp 2

Are there supposed to be more?

Cheers

 
Upvote 0 Downvote
That is all they have. If you are using this on the shop floor, then there really isn't much you can do. That is all they have. You can investigate hooking call manager into the loud speakers if you have them so that when a call comes in it is also announced over the speakers. This can be done using an analog line and a little research.

How are your 7920s working for you?

We run 3 here in our offices. We have spent a lot of time working on them and find them to be very reliable while standing still and somewhat reliable while roaming. 1.8 really helped out, but we get some interferance from neigboring offices who run 802.11b/g and an 802.11 bridge on our roof (not ours).

What is your expereince?


It is what it is!!
__________________________________
A+, Net+, I-Net+, Certified Web Master, MCP, MCSA, MCSE, CCNA, CCDA, and few others (I got bored one day)
 
Upvote 0 Downvote
The 7920's seem to work really well. We are currently running two sites with about 45 handsets and about 40 AP's. (the sites are very big!)

There are a few niggles, the ring tones being one of them.
A shared address book has also been requested a number of times.

We have only just upgraded to the 1.08 firmware, so its a little early to see what difference that has made.

We get no interfance (we are in the middle of nowhere though).

Regards

Ray
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

mikedphones
  • Locked
  • Question Question
MASS - Looking for a Cisco Call Manager support tech to move and reconfigure
Replies
0
Views
831
mikedphones
mikedphones
Gnjiro
  • Locked
  • Question Question
Cisco Ip Phone 7841, 7821 Delay when making call both inbound and outbound in sip protocol
Replies
3
Views
1K
thepfy
thepfy
jrothwell
  • Locked
  • Question Question
CMBE5000 / CUCM and Unity 8.6.2 licensing
Replies
0
Views
407
jrothwell
jrothwell
Geordie12567
  • Locked
  • Question Question
Maximum concurrent calls on a SIP trunk with CUCM and Cube
Replies
2
Views
911
biglebowski
biglebowski
Siva reddy
  • Locked
  • Question Question
No audio when calls made from and to Cisco ip communicator over new Sip trunks
Replies
3
Views
761
gnrslash4life
gnrslash4life

Part and Inventory Search

Sponsor

Back
Top