davidwalters
IS-IT--Management
I am trying to set up a line pool access code [ 7 ]. When I enter SYSTEM PROGRAMMING / ACCESS CODES / LINE POOL CODES / LINE POOL O: [ 7 ], it will not accept only [ 7 ]. I can enter [ 77 ] and then I get OK but not just [ 7 ].
I have checked for DN numbering conflicts and there are non also any HUNT GROUPS. I did have 7xx in the HUNT GROUPS but I changed them to 6xx. I can;t find any in MAINTENANCE either. I usually can find these as I have used POOL CODE [ 7 ] in the past on other systems but I am stumped on this one.
The system DN's are 200s and 300s. I get INVALID NUMBER when I dial [ 7 ]. If I program [ 77 ] for POOL O that will work. I am using [ 9 ] for the PRI. This new pool points to a restricted international access using LOOP LINE-001 only single analog line only to be used for Admin DN sets.
I have checked for DN numbering conflicts and there are non also any HUNT GROUPS. I did have 7xx in the HUNT GROUPS but I changed them to 6xx. I can;t find any in MAINTENANCE either. I usually can find these as I have used POOL CODE [ 7 ] in the past on other systems but I am stumped on this one.
The system DN's are 200s and 300s. I get INVALID NUMBER when I dial [ 7 ]. If I program [ 77 ] for POOL O that will work. I am using [ 9 ] for the PRI. This new pool points to a restricted international access using LOOP LINE-001 only single analog line only to be used for Admin DN sets.
