5610SW IP

[fsoz]

I've got a 5610 thats been disconnected for a couple of months, now it doesn't work. Phone goes through the motions and stops at Discover: 10.0.0.61 Phone IP is 10.0.0.98 Can ping both addresses, can't think of any changes to the IPO406 v2

 

[amriddle01]

Do a "Hold, CLEAR" on the handset and try entering the parameters again

ACS - IP Office Implement

"What the Crocodile Hat....was that?

 

[fsoz]

How do you do a "Hold, CLEAR" ?

 

[Bas1234]

First press Hold (leave the handset on the PHONE!) then press CLEAR (25327) # and # again.

Also depending on how your network is setup you might neet to enter a VLANID, you better should ask you BP how he set this up.

___________________________________________
It works! Now if only I could remember what I did...

Dain Bramaged
___________________________________________

 

[amriddle01]

In fact you will need to boot the phone and then press * to programme when prompted during the boot phase, it needs to be logged in for Hold, CLEAR (You press hold then type CLEAR on the keypad to resel all values)

ACS - IP Office Implement

"What the Crocodile Hat....was that?

 

[intrigrant]

Start up the phone, when it displays "press * to program" then press * and repeatingly press # until you get the message "enter command", the press the HOLD key followed by CLEAR (25327) and then #.
So sequentially you press HOLD25327#, it will ask if you want to erase all settings, confirm that by pressing the appropriate key.