5550 ip console trying to connect to 2 ICPs after address change

[Tinos]

Hi all.
I have changed the IP address of my controller.
After running the configuration wizard for the 5550 IP console I put in the IP of my ICP, and it finds it. But, it also finds the old ICP IP address. Any suggestions on how to fix this? (the Console will not come up all the way, it keeps fighting between the ICP's it thinks it needs to connect to)

 

[Tinos]

I have uninstalled and reinstalled the 5550 and rebooted the ICP and the issue is still the same.
Finally edited the config file and it has connected.
Not sure if it will have full functions and if this is the recommended fix and also why this condition occurred.
Please assist further.

 

[Mitel_specialist]

I don't know which software release you are using but did you also changed the IP address at 'ICP/PBX Networking' form?
If not you should do that and perform a reboot of the system