How do you communicate to client devices attach to the 516-CS? I have over 7 devices with crossover cable's going to 516. Im in hyperterminal what are the commands to use? So far i can only communicate with the 516. I have not yet configure the ethernet address because i need a ethernet transceiver. If I do a show tty i do see the devices are active but i need to access them for configuration. I check cisco site all they have is inital hardware setup. Any suggestions, thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
516-CS Device Setup
- Thread starter UNIX72
- Start date
- Thread starter
- #2
Dude-- dont run off mad.. I had posted but I guess it did not take. Write to me offline.. I have these beasties.. I use them for my rental lab, run TACACS on them and run IOS 10.3 instead of the ROM based 9.x
MikeS
webmaster at packetattack dot com Find me at
"The trouble with giving up civil rights is that you never get them back"
MikeS
webmaster at packetattack dot com Find me at
"The trouble with giving up civil rights is that you never get them back"
- Status
Similar threads
