Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

500 v2a with analog trunk from a DMS-10 issue with disconnect

Status
Not open for further replies.

DigitalG

Technical User
Mar 11, 2005
430
CA
system = ipo 500 v2 version 11.1.2.4.0
VMpro

I use assisted trasfer in my vmpro module.

trunk = analog from a DMS-10 ( dont laugh! )

Trunks from a LCE card 6 X17

Trunks from a PE card 2T00

isssue is when i call the auto attendent, if y try to reach an extension and then if i hang up, i will still continue to ring ( connected blind ) to the extension ( on the 2T00 card )





I need your help


 
the analog line will always take time to disconnect even if you have disconnect supervision on it which means that the voltage is dropping for 500 ms to signal to the system that the caller has hung up.

If you do not have disconnect supervision then you have to enable busy tone detection and hope that it hangs up but it will always have a delay of 1 - 2 rings even with that.

Joe
FHandw, ACSS, ACIS

"Dew knot truss yore Spell Cheque
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top