Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
500 sets staying disabled on a CS1000
- Thread starter Daren666
- Start date
Firebird Scrambler
Systems Engineer
That's odd as usually the midnight routines disable digital sets that aren't connected. Analogue sets aren't really affected as the system can't test them.
Two choices
One, stat the card slots in LD 32 using e.g. STAT "004 0 0" etc. You can also stat the individual TN.
Look for ones that are disabled.
Once you have found them, go into LD 10
REQ: OUT
TYPE 500
TN "TN"
Sometimes, they can't be removed if the set is being monitored or it belongs to a hunt group. You need to remove the DN from the hunt group and the TN from the digital set that is monitoring it.
The attached guide is old but is easy to follow.
Firebird Scrambler
Nortel & Avaya Meridian 1 / Succession & BCM / Norstar Programmer
Website = linkedin
Two choices
One, stat the card slots in LD 32 using e.g. STAT "004 0 0" etc. You can also stat the individual TN.
Look for ones that are disabled.
Once you have found them, go into LD 10
REQ: OUT
TYPE 500
TN "TN"
Sometimes, they can't be removed if the set is being monitored or it belongs to a hunt group. You need to remove the DN from the hunt group and the TN from the digital set that is monitoring it.
The attached guide is old but is easy to follow.
Firebird Scrambler
Nortel & Avaya Meridian 1 / Succession & BCM / Norstar Programmer
Website = linkedin
- Status
Similar threads
- Locked
- Question