howdy!
My problem i'm sure is simple compared to most, i have a mixed subnetted network, all public ip addresses on different subnets (that are not right beside each other, 58.0, 94.0, 11.0..) and im wanting to route between these subnets without going through my router and firewall to route them. I have got this switch (4500g 48pt) to do inter-vlan routing and/or routing the way i want it to if i increase the mask to 255.255.0.0 but then i no longer have access to all the other computers that aren't on my network in the same range.
I have seen where other layer3 switches you can just add multiple ip addresses to the vlan1 interface but i cant seem to be able to do this, maybe I'm doing it wrong though who knows. thanks!!
My problem i'm sure is simple compared to most, i have a mixed subnetted network, all public ip addresses on different subnets (that are not right beside each other, 58.0, 94.0, 11.0..) and im wanting to route between these subnets without going through my router and firewall to route them. I have got this switch (4500g 48pt) to do inter-vlan routing and/or routing the way i want it to if i increase the mask to 255.255.0.0 but then i no longer have access to all the other computers that aren't on my network in the same range.
I have seen where other layer3 switches you can just add multiple ip addresses to the vlan1 interface but i cant seem to be able to do this, maybe I'm doing it wrong though who knows. thanks!!