l33byt1980
Vendor
For some reason I have 2 4500 26 port switches which I cannot seem to get stacked.
Based on this;
[4500]change unit-id 1 to 1
[4500]fabric-port gigabitethernet1/0/51 enable
[4500]fabric-port gigabitethernet1/0/52 enable
[4500]sysname hello
[hello]xrn-fabric authentication-mode simple welcome
if I do a display XRN it only shows the console connected switch and not the other switch as i want part of the stack. They have both been configured as above except the second switch is set as change "Unit-id 1 to auto numbering"
I have hard rebooted the switches but all i get is a flashing status on led 28.
Any ideas what is happening here.
ACA - IPOffice implement
ACA - IP Telephony
CCNA - Passed at last
Based on this;
[4500]change unit-id 1 to 1
[4500]fabric-port gigabitethernet1/0/51 enable
[4500]fabric-port gigabitethernet1/0/52 enable
[4500]sysname hello
[hello]xrn-fabric authentication-mode simple welcome
if I do a display XRN it only shows the console connected switch and not the other switch as i want part of the stack. They have both been configured as above except the second switch is set as change "Unit-id 1 to auto numbering"
I have hard rebooted the switches but all i get is a flashing status on led 28.
Any ideas what is happening here.
ACA - IPOffice implement
ACA - IP Telephony
CCNA - Passed at last